Magnetic power bank
A small aluminium power bank that attaches magnetically to your phone and doubles as a phone stand.

The idea
A power bank small enough to hold, designed to attach to an iPhone with MagSafe. Black aluminium, five neon-green bars for charge, one button and one USB-C port for both input and output.
Once it is on the phone, it should also stand the phone upright.
- Size
- 100 × 65 × 15 mm
- Housing
- Black anodised aluminium
- Interface
- Five charge bars, one button, one USB-C
The first version
We sized it at 100 × 65 × 15 mm and placed the charging centre high, so the phone’s camera stays clear. A single flush leg folded out of the back. We moved USB-C to the top edge so a cable clears the desk, and checked the hinge through its sweep for clashes.
Finding the form
The first stand was a plain leg, and it did not look designed. We made it a compact panel a third of the body’s height, 33 mm, with a concealed hinge and a slim silicone foot. The shorter leg holds the phone at a 35° recline.
The button and the five charge bars moved up to the top edge with USB-C, so every control lives in one row.


Getting the details right
On the phone-facing side we engraved a shallow alignment ring and bar, centred on the magnets. We tried a geometric pattern on the back, then removed it to keep the back plain.
Neon green is used sparingly: the ring and bar, the charge windows and a fine stripe along the lower edge. The body corners became continuous curves, and the top controls moved slightly inward to stay on the flat.


The result
A black aluminium block with one row of controls and a stand that sits flush when closed. The model stays editable by its dimensions. Charging, magnetic hold and stand stability are next, on a physical prototype.

Start with what you have.
A sketch, a reference, a rough idea. Let’s figure out the next step together.