Product design

Bonsai lamp

A bonsai-inspired table lamp in cast bronze, ceramic and frosted glass.

Bonsai lamp with a leaning bronze trunk, three branches ending in flat cloud-shaped canopies, on a shallow ceramic base.

The idea

A table lamp with the structure of a mature bonsai. A short, thick trunk rises off-centre from a shallow oval base, leans sideways, then curves up and divides into three branches.

Each branch ends in a flat, cloud-like canopy that throws warm light down. The lamp should feel grounded at the base and more delicate toward the crown.

Height
451.4 mm
Light
Three canopies, lit downward
Materials
Cast bronze, frosted glass, ceramic

Finding the form

We set out the composition first: a low, wide base, a leaning trunk, the largest canopy reaching furthest, and two smaller ones stepping back toward the top. The lowest branch reaches out, the middle one goes the other way, and the top one curves in to form the crown.

The first form review liked the composition but not the finish. The canopy tops were dished and the branch joints were sharp. We smoothed those transitions and made the crown shell thinner.

Bonsai lamp from the front, with branches reaching left and right.
Bonsai lamp from the side, showing the stacked canopies.

Getting the details right

The trunk and branches are hollow cast bronze, so the wiring runs out of sight. Each canopy pairs a thin dark-bronze shell with a recessed frosted-glass diffuser, held on a collar where the module attaches.

At the base, root-like supports flare out and anchor the trunk. Inside the ceramic, a hidden steel plate balances the reach of the branches.

Close-up of a canopy, showing its thin bronze rim and frosted-glass underside.
A thin bronze shell over a frosted diffuser.
Close-up of root-like supports flaring from the trunk onto the ceramic base.
Roots flare from the trunk to anchor it.

The result

A 451.4 mm sculpture and light, modelled as 21 solids. The next step is resolving the fabrication details.

Bonsai lamp from the rear three-quarter.

Start with what you have.

A sketch, a reference, a rough idea. Let’s figure out the next step together.

Book a call